9
10
1-877-646-5288
ninjakitchen.com
ENGLISH
Before First Use
Fig. 2
Fig. 1
Assembly and Use of the Pitcher
Shaft
Fig. 4
ASSEMBLY
1
Remove all packaging material and labels
from the appliance. Separate all parts from
each other.
2
Wash the lid, pitcher, and stacked blade
assembly in warm, soapy water. When
washing the stacked blade assembly, use
a dishwashing utensil with a handle to
avoid direct hand contact with blades.
3
Handle blade assemblies with care to
avoid contact with sharp edges. Rinse and
air-dry thoroughly.
4
The pitcher, lid, and stacked blade
assembly are all dishwasher safe. It is
recommended that the lid and Stacked
Blade Assembly go on the top rack.
Ensure the stacked blade assembly is
removed from the pitcher before placing
in the dishwasher.
5
The motor base can be wiped clean with
a damp cloth.
Fig. 3a
Fig. 3b
OR
1
Review the warnings and important
safety instructions on pages 1–2 before
proceeding to step 2.
2
Place the motor base on a clean, dry,
level surface.
3
Lower the pitcher onto the motor base
(Fig. 1)
.
4
Rotate the pitcher to the left as far as it
will go. The pitcher can be placed on the
motor base two ways; the handle can be
on the front right corner or the front left
corner. As the pitcher rotates, it will lower
and the safety tabs on the bottom of the
pitcher will slide under the safety tabs on
the top of the motor base
(Fig. 2) (Fig. 3a,
Fig. 3b)
.
NOTE:
As a safety feature, the motor will
not work if the pitcher and lid are not
installed correctly. When the pitcher and
lid are installed properly, the ready light
will be solid, indicating the blender is
ready for use.
5
Holding the Stacked Blade Assembly
by the shaft, place it onto the gear shaft
inside the pitcher
(Fig. 4)
.
Ensure that
the Stacked Blade Assembly fits around
the gear shaft and that the blade shaft is
standing straight.
NOTE:
The stacked blade assembly will fit
loosely on the drive gear.
6
Add the ingredients to the pitcher. Make
sure ingredients don't go higher than the
highest measured marking line on the side
of the pitcher.
NOTE:
When blending any kind of
liquids, such as mixtures of any drinks or
smoothies, do not exceed the “Max liquid”
mark (1.9 L) on the pitcher.
WARNING: Stacked Blade
Assembly is sharp and not
locked in place. If using the
pour spout, ensure the lid is
fully locked onto the pitcher.
Failure to do so will result in
a risk of laceration.
WARNING: Stacked
Blade Assembly is sharp
and not locked in place.
If pouring with the lid
removed, carefully remove
the Stacked Blade Assembly
first, holding it by the shaft.
Failure to do so will result
in a risk of laceration.
