11
ninjakitchen.com
10
ninjakitchen.com
1
Place the motor base on a clean, dry, level
surface such as a counter or table top.
2
Align and lower the Pitcher onto the
motor base. Handle should be aligned
slightly to the right of the “LOCK”
symbol on the motor base.
USING THE BLENDER PITCHER
3
Rotate the blender pitcher clockwise
until it clicks in place. As the pitcher
rotates, it will lower and the safety tabs
on the bottom of the pitcher will slide
under the safety tabs on the top of the
motor base.
4
The pitcher can be placed on the motor
base two ways; the handle can be on
the front right corner or the front left
corner.
5
Holding the Stacked Blade Assembly
by the top of the shaft, place it onto the
drive gear inside the pitcher. Ensure that
the Stacked Blade Assembly is seated
properly and is standing upright.
6
Add the ingredients to the pitcher,
making sure that they do not exceed the
highest measured marking line on the
side of the pitcher.
7
Plug the power cord into the electrical
outlet and press the power button ( ).
IMPORTANT:
Review all warnings
on pages 4–7 before proceeding.
NOTE:
DO NOT
add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE:
If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
8
Holding the lid by the handle in the
upright position, place it on top of the
pitcher aligning the arrow ( ) located
on the lid with the arrow ( ) located on
the pitcher’s handle. Press the handle
down until you hear a click.
IMPORTANT:
As a safety feature, the
power button ( ) will flash and the
motor will not work if the pitcher and
lid are not installed correctly. When the
pitcher and lid are installed properly, the
power button ( ) will be solid, indicating
that the appliance is ready for use.
NOTE:
The Stacked Blade Assembly will
fit loosely on the drive gear.
TIP:
It’s best to add the liquid ingredients
first and then the dry ingredients.
9
Select the speed that best suits your
needs.
10
When you have reached your desired
consistency, stop the appliance by
pressing same button again or select
the power button ( ) and wait for the
attachment to stop turning.
11
To remove the lid, press the release
button on the lid, pull the lid handle up
to a 90° angle and lift the lid off. Turn
the pitcher counter clockwise and then
lift off the base.
12
For thicker consistencies, first remove
the lid by pressing the release button
and pulling the lid handle up to a 90
degree angle to lift lid off the pitcher.
Then, carefully remove the Stacked
Blade Assembly by the top of the shaft.
Place Stacked Blade Assembly away
from the work area to avoid accidental
contact. Finally, empty contents from
the pitcher.
13
Make sure that the unit is unplugged
when not in use.
14
To release the motor base from the counter
or table top, place your hands underneath
both sides of the motor base and gently
pull the unit up and towards you.
