7. Approximately one foot from each tie down double-loop of the Ninja Jump
unit, drive an anchor to the ground at a 45
°
angle with the head pointing
away from the Ninja Jump unit. Secure the Ninja Jump unit at all times to
the corresponding number of anchors. Use the straps to attach the anchors
to all the double-loops as provided in specific areas on the base of the
Ninja Jump unit.
Large units with high profiles (Giant Slides, etc) have additional tie down
loops that are located at higher points. Each of these additional locations
should also be attached to the anchor at a 45
°
angle.
When the unit is on hard surface (cement, wood floors, etc.), substitute a
sand bag with adequate weight for the anchor.
8. Plug the blower into the closest properly grounded (GFCI) 11 Ov outlet only
after you carefully read the blower manufacturer's safety instructions.
Turn the switch on and wait (approximately 2 minutes) until the inflatable
is fully inflated and the equipment and all parts have been examined for
potentially unsafe conditions before letting children in the inflatable.
9. This unit requires continuous air pressure. Do not turn the blower off while
children are in the inflatable.
- 4 -
