Trueshopping
www.Trueshopping.co.uk
NEVER open the Pressure Cap during use, unless you have correctly followed the
instructions elsewhere in this guide. The Pressure Cap can get hot in use; handle it
with care.
Accessories
1. Water tank 12.Wheels
2. Pressure Cap 13.Snap on extension wands
3. Carry handle 14. Floor Brush
4. On/off switch 15. Floor angled detail tool
5. Operating indicator 16. Adaptors for accessories
6. Steam indicator switch 17. Multi-purpose round brushes
7. Accessories store 18. High pressure nozzle
8. Fixed steam hose 19. Squeegee head
Trueshopping
www.Trueshopping.co.uk
9. Steam Gun 20. Measuring jug, funnel and cleaning cloth
10. Steam trigger
11. Red Safety button
Technical data: Mains supply: 230V-50Hz, Power: 1500W, Tank capacity:
1.5 litres.
Using for the first time
Make sure the machine is unplugged from the mains.
Unscrew the safety cap (2) by pushing down and turning anti clockwise.
Using the measuring jug and funnel (15) fill the machine with up to 1500ml
of water. This should be sufficient to steam clean for approximately one
hour.
Once full, replace the safety cap by turning clockwise and fasten tightly.
Attach the accessory or floor cleaning tool you require to the machine.
Now plug the machine into the mains and switch on. Two lights should
illuminate. The red light (5) is a power indicator. The orange light (6)
indicates that the machine is building up steam pressure. When the
machine is first turned on this light will illuminate and the machine can take
up to 12 minutes to reach the correct pressure level depending on the
amount of water in the tank.
Once the orange light has gone out the machine is ready to use. The
orange light may come back on when the machine is in use. If this
happens, release the safety trigger and allow the steam pressure to build
up once again. This should take no longer than 40 seconds. If the safety
trigger is pressed when the orange light is on hot water may come out of
the machine.
Refilling the water tank
Switch the machine off using the on/off button (4)
Disconnect the power cable from the mains. Wait five minutes before
squeezing the safety trigger to make sure that the machine is no longer
under pressure before unscrewing the safety cap. DO NOT unscrew the
safety cap until the steam has stopped.
Fill the water tank as necessary using the funnel provided.
DO NOT exceed 1500ml of water before replacing the safety cap by
turning clockwise. Fasten cap tightly.
