7.
Swing function:
To activate the Swing feature, touch the
SWING
button once. Touch the
SWING
button again to turn
the Swing feature off.
Warning:
The heater will remain hot for some time after it is
turned off; handle with care.
Always turn off
the Mains power switch
and remove
the power plug from the mains outlet after use.
REMOTE CONTROL
The remote control requires one "CR2032" type 3-volt
lithium battery (included). To extend the life of the
original battery we have inserted a small clear plastic
spacer tab between the lithium battery and the
battery terminal. Please remove this battery spacer tab
before using.
•
If the operation of the remote control becomes
unsatisfactory, replace with a new 3-volt lithium
battery.
1.
Place the remote control with the control buttons
facing downward.
2.
Touch the locking arm of the battery cover and
pull out the tray.
3.
Take out the exhausted 3V CR2032 battery and
replace a new one into the battery tray with the
positive
“
-
” side facing up, observing the polarity
markings. If the battery is placed incorrectly, the
remote control will not work.
4.
Insert the battery holder into the battery
compartment.
•
Using the Remote Control to operate the
appliance
1.
For the best results, aim the Remote Control
directly at the remote sensor on the front
panel of the heater.
2.
Do not put any objects between the Remote
Control and the heater while operating the
appliance.
3.
Operate the remote control within a 3-meter
range and an angle of 60 degrees.
Notes:
1.
Keep batteries out of children’s rea
ch.
2.
Remove the battery if it is exhausted or if the
remote control is not being used for a long time.
3.
When there is a strong ambient light source, the
performance of the infrared remote sensor may
be degraded, causing unreliable operation.
4.
Batteries contain chemical substances, so they
should be disposed properly.
