background image

This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.

The battery complies with UN/DOT 38.3.

The battery complies with ANSI/UL 2271.

Federal Communications Commission (FCC) Compliance Statement for USA

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device 

may not cause harmful interference, and (2) this device must accept any interference received, including interference 

that may cause undesired operation.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of 

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures: 

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help.

Industry Canada (IC) Compliance Statement for Canada

This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two 

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including 

interference that may cause undesired operation of the device.

CAN ICES-3 (B)/NMB-3(B)

10 Certifications

16

17

9 Specifications

Machine

Battery 

Motor

Charger

Features

Tire

Brake Light

Length x Width x Height

Payload

Rider

Recommended Age

Required Height 

Max. Speed

Typical Range

 

[1] 

Max. Slope

Operating Temperature

Storage Temperature

IP Rating

Duration of Charging

Traversable Terrain

Max. Charging Voltage

Charging Temperature

32–104°F (0–40°C)

Nominal Capacity

Battery Management System

Input Voltage

Output Voltage

Output Current

Nominal Voltage

Nominal Power

Output Power

Approx. 46.6 × 18.8 × 46.3 in (1183 × 478 × 1175 mm)

66–220 lbs (30–100 kg)

Approx. 

Approx. 14%

36 VDC

14–104°F (-10–40°C)

-4–122°F (-20–50°C)

42 VDC

A 551 Wh,   B 1004Wh

0.35 kW, 350 W

Over-heating, short circuit, over-current, over-discharge, and
over-charge protection

100–240V

 

42 VDC

5 A

0.21 kW, 210 W

18+ years

3’11”–6’6” (120–200 cm)

IPX4 (controller IPX7, and dashboard IPX7)

Approx. 4 h

asphalt/flat pavement; obstacles < 0.4 in (1 cm); 
gaps < 1.2 in (3 cm)

Approx. 15.5 mph (25 km/h)

LED rear light

Riding Modes

Tires

Energy Saving mode, Standard mode and Sport mode

Inflation-free/filled with foaming PU

Net Weight

Approx. 

Item

Parameter

[1]

 

Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement.

*

 Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.

Product

Model   

T60

Содержание Segway Shared Kickscooter T60












Отзывы: