Ninebot KickScooter F65, Руководство по эксплуатации продукта

Страница: 5 / 18

EN EN
Recommended Maintenance Schedule
5
To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have control and knowledge of
how often you use your scooter, how hard you use it and where you use it. It is the owner's responsibility to perform regular checks
and bring your scooter to authorized service center for inspection and service. Please refer to the maintenance schedule
below.
Note: This maintenance schedule charges a service fee.
Item Component
Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.
Tire pressure
Inflate tires to 40–45 psi. Note: Remember to screw
the valve cap after inflating!
Tire wear
Screws on the
stem top
Mainframe
maintenance
Screws on the
folding
mechanism
Check if the tires are cracked, deformed, or
significantly worn.
Tighten the six screws fixed with the handlebar and the
stem. The suggested torque is 3.0
±
1.0 N·m.
Tighten the screw on the throttle. The suggested
torque is 2.0 N·m.
Tighten the screws on the brake levers. The suggested
torque is 7–9 N·m.
Tighten the screws on the stem top. The suggested
torque is 10
±
0.5 N·m.
Tighten the two screws fixed with the front fork and the
folding mechanism. The suggested torque is 10
±
1 N·m.
If the stem gets shaky when riding, tighen the screws on the
folding mechanism when the scooter is in folded state.The
suggested torque is 15
± 1 N·m.
Maintenance Method
Every 3
months
Every 6
months or
every 310
miles (500
km)
After 2 years or
the total
mileage > 3107
miles (5000
km)
√ √
√ √
√ √ √
√ √ √
√ √ √
√ √
Item Component
Hub motor
Rear wheel
maintenance
Brake
adjustment
To accelerate and decelerate, check if the hub motor is stalled
or has abnormal sounds.
Check if the rear wheel is stalled or gets shaky, or the axis shaft
is unbalanced.
If the brake is too loose/tight, tighten/loosen the adjusting
screw on the drum brake clockwise/counterclockwise to
adjust its position.
Maintenance Method
Every 3
months
Every 6
months or
every 310
miles (500
km)
After 2 years or
the total
mileage > 3107
miles (5000
km)
√ √
√ √
√ √
Taillight Squeeze the brake lever, the taillight works normally.
Function
Inspection
Headlight Check the headlight and see if it lights brightly.
Dashboard Power on the scooter, the dashboard works properly.
Bell Ring the bell, the sound should be loud.
Throttle
Charging
Steering
Buttons
app
detection
Press and hold the throttle, then release it, checking for
acceleration and deceleration.
After connecting with the Segway-Ninebot app:
1) Update the firmware to the latest version.
2) Check if the notification of the corresponding error code and
possible causes will prompt when the scooter detects an error.
Charge the scooter:
1) Check if the current battery power displays on the dashboard.
2) Check the LED indicator on the battery charger.
Charging: red, Fully charged: green.
Press or toggle the button 3 times without failure.
Test with left turns and right turns (the steering angle is 60).
No resistance or lag when turning.
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
Direction
indicators
Toggle the direction indicator button to the left/right
respectively, check if the direction indicators on the left/right
side flash normally.
√ √
√ √
01 02 03 04 05 06 07
10 11 12 13 14 15 16 17
18 19 20 21 22 23 24 25
26 27 28 29 30 31
08 09