Flight preparation
Open the battery compartment and insert the dry or rechargeable cells. Close
the battery compartment. Move all the switches to the forward position, then
switch the transmitter on (Fig. 1). If switch "A" or "B" is at the "ON" position, the
screen will flash and the transmitter will beep; at these switch positions the trans-
mitter cannot be switched off.
Move the collective pitch / throttle stick and trim to their lowest position. Other-
wise the motors will not start.
Carefully pull the canopy forward and off, fit the charged LiPo flight battery into
the support frame on the helicopter, and connect the LiPo flight battery (Fig. 2).
Do not touch the throttle control. Do not touch the model for at least three se-
conds, otherwise the initialisation process cannot take place.
Repeat this procedure every time you wish to fly the model.
The "3D" aerobatic switch SW(B) should only be operated by experienced pilots.
Moving the switch to the "ON" position sets a system rotational speed suitable
for aerobatics.
The hover rotor speed can be adjusted using the "Hover throttle setting" rotary
knob.
Note: the 2.4 GHz transmitter and receiver are supplied already bound at the
factory. It will only be necessary to bind the system again after a repair, or if you
replace a component.
13
Fig. 2
Fig. 1
A
W
Operating Instructions, SOLO PRO 319 RTF 2.4 GHz No. NE2517
