Flight preparation
Open the battery compartment and insert the dry or rechargeable cells. Close
the battery compartment. Move all the switches to the forward position, then
switch the transmitter on (Fig. 1). If switch "A" or "B" are at the "ON" position, the
screen will flash and you will hear a "beep" to alert you. The transmitter cannot
be switched on with the switches in this position.
Move the collective pitch / throttle stick and trim to their lowest position. Other-
wise the motors will not start.
Carefully withdraw the canopy forward, then slide the charged LiPo flight battery
into the helicopter's support frame and connect the battery (Fig. 2). Take care not
to touch the throttle (rotor speed) control. Do not move the model for a minimum
of three seconds, otherwise the initialisation process will not take place.
Repeat this procedure every time you wish to fly the model.
The "3D" aerobatic switch SW(B) should only be operated by experienced pilots.
Moving the switch to the "ON" position sets a system rotational speed suitable
for aerobatics.
The hover rotor speed can be adjusted using the "Hover throttle setting" rotary
knob.
Note: the 2.4 GHz transmitter and receiver are supplied already bound at the
factory. It will only be necessary to bind the system again after a repair, or if you
replace a component.
13
Fig. 2
Fig. 1
A
W
Operating Instructions - SOLO PRO 130 EC145 RTF 2.4 GHz No. NE2522
