Nine Eagles Galaxy Visitor 7, Инструкция по эксплуатации

Страница: 11 / 28

3)Gain setting
4)Transmitter calibration
Press the left stick and right
stick at the same time
5)
Acceleration sensor calibration by transmitter
Bi--
1.Press the right stick and
keep pressing it 2.Press the throttle stick (the
left stick) quickly for three times
7
press the throttle stick (the
left stick) one time to save
【
Picture
11
】
【
Picture
1
2
】
【
Picture
1
3
】
GALAXY VISITOR 7
NE-MASF25
Power on the transmitter and connect li-po battery to the quadcopter.
After successfully bound, lower the throttle stick to its lowest position.
Press the right stick and keep pressing. The constant voice “Bi” will appear. Now the transmitter
enters into gain setting mode.
Push throttle stick upper to the value you need. The voice will turn to incontinuous “Bi, Bi, Bi”.
Then release the right stick and then the transmitter will save the value.
A.Power on transmitter.
B.Press the left stick and the right stick at the
same time, wait until the transmitter sounds “Bi,
Bi, Bi, Bi”. Now the transmitter enters into
calibration mode.
C.Move the right stick to its maximum position in
four direction: up, down, left and right. Then
move the right stick to its middle position.
Repeat the above operation to the left stick.
D.Push the rudder trim button to the right for one
time, then the transmitter will quit calibration.
If quadcopter nose-rotating is not normal, we need
to do acceleration sensor calibration.
A.Please follow the instructions Power on
transmitter and Connect quadcopter and Li-po
battery on Section 6. Flying.
Make sure the throttle stick (the left stick) at its
lowest position and hold it. Then power on
transmitter. After that, release the throttle stick
(the left stick) free.
B.Connect li-po battery to quadcopter and make
sure to keep the quadcopter stay still and quite
on flat surface, now the tail indicator light will be
solid on.
C.Press the right stick and keep pressing it. Then
press the throttle stick (the left stick) quickly for
three times in a very short time. When the
transmitter makes a “Bi” sound, the transmitter
is in calibration mode, then loosen both the left
and right stick.
D.Then move the throttle stick at its lowest
position and hold it.
E.Push the throttle trim button upwards and then
the tail indicator light turns to quickly flashing.
F.During its flashing, press the throttle stick (the
left stick) one time to save. Finally the tail
indicator light will be solid on. Acceleration
sensor calibration is done.
When quadcopter can not do hovering and fly to one side, we need to do calibration by following
the below steps.