NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l’Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 ·
www.nincoair.com
- 6 -
Transmitter
Switch Charge/Off/On
On / Off indicator LED
Charge indicator LED
Turn right / left
Forward / backward
Up / down
Trim
Tri-band channel
Cover and charge wire
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1. Open the battery cover.
2. Fit the batteries (respect polarity).
3. Close battery cover.
Helicopter:
Switch in position OFF.
1. Open the charger cable cover.
2. Connect the cable to the helicopter.
3. Turn the switch of the transmitter in CHARGE position.
4. Red LED will turn on. When the process finishes the LED will turn off. (Charging time approx. 30-40 min).
5. Disconnect the plug. The flying time is 5-7 min.
HELICOPTER FLIGHT
1. Select the band in the transmitter A, B o C and the helicopter will automatically identify it.
2. With the helicopter switched off, first switch on the transmitter.
3. Switch on the helicopter.
4. Place the helicopter in the floor.
5. Synchronizing transmitter and helicopter: Full push the left stick for a second.
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it clockwise o vice versa until the helicopter stops turning.
Flight control:
Up
Push left stick
Down
Pull left stick
