Nilfisk-Advance SelectSpray 1500EH, Инструкция по эксплуатации и список запасных частей

Страница: 10 / 52

10 Nilfisk-Advance Select Spray 1500E Operator's Manual
INSTALLATION & PREPARATION
ATTIRE:
1. Proper attire is essential to your safety. It is advised to utilize whatever
means necessary to protect eyes, ears, and skin. Additional safety attire
(such as respiratory mask) may be required when using detergent cleaning
agents with this washer.
SET-UP:
1. This unit should only be placed on a level surface to ensure proper lubrication
for the water pump while operating. NEVER spray water directly on the unit!
2. Do not place unit in an area:
-where there is evidence of oil or gas leaks.
-where flammable gas vapors may be present.
3. Do not allow the unit to be exposed to rain, snow or freezing temperatures. If
any part of the unit becomes frozen: excessive pressure may build up in the
unit which could cause it to burst, resulting in possible serious injury to the
operator or bystanders.
4. Make sure the oil level is in the center of the sight glass. Pump oil level should
be checked before each use. If low, fill with SAE 30W Non-detergent oil. DO
NOT OVERFILL!
WARNING
RISK OF EXPLOSION!
DO NOT OPERATE UNIT IN AN
AREA WHERE FLAMMABLE GAS
VAPORS MAY BE PRESENT. AN
ELECTRIC SPARK MAY CAUSE
AN EXPLOSION.
RISK OF BURSTING!
DO NOT STORE / OPERATE UNIT
IN A FREEZING ENVIRONMENT.
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
NEVER LOOK DIRECTLY AT THE
NOZZLE ORIFICE UNLESS IT IS
DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
WHEN USING THE ADJUSTABLE
NOZZLE, NEVER ADJUST THE
SPRAY PATTERN WHILE THE
TRIGGER GUN IS OPEN!
NOZZLE REVIEW:
NOTE: Nozzle assembly should NOT be connected to the gun assembly at this
time.
1. Selection of high pressure can be achieved by turning the protective collar
clockwise as shown in Figure 1, left. While in the high pressure mode, water
is directed solely through the 15° spray nozzle creating a concentrated high
pressure "fan" spray.
2. Selection of low pressure detergent application can be achieved by turning the
collar
counterclockwise as shown in Figure 2, left. Once the pressure is low
enough, the detergent injector on the pressure washer will draw detergent into
the system. As the collar is turned, a water/detergent mixture exits not only from
the spray nozzle, but also around the nozzle. This creates a "fan/cone"
combination spray pattern.
OMGEN224/021696/DCE