8 - FORM NO. 56041454 / SELECTGLOSS 20B
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
INSTALLING A PAD
Your local Kent Distributor can provide the proper pads and floor finishes for use with this machine.
CAUTION!
Using the wrong kind of pad on this machine can damage the floor.
1
Lower the pad drive assembly onto the floor, using the Pad Lower Lever (7) on the back of the machine. Then push the back of the machine down until the
support stand touches the floor.
WARNING!
Do not pull down on the front of the machine while installing or removing the pad.
2
Turn the pad retainer clockwise to remove it from the pad holder. Carefully center a burnishing pad on the pad holder. If the pad is not centered properly,
the machine will vibrate when the pad motor is started.
3
Install the pad retainer by turning it counter-clockwise. Tighten the pad retainer securely.
4
Put your foot on the support stand and gently lower the front of the machine to the floor.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
INSTALLING DUST COLLECTOR BAGS
1
Lower the pad drive assembly onto the floor, using the Pad Lower Lever (7) on the back of the machine. Then push the back of the machine down until the
support stand touches the floor.
2
Install two dust collector bags (Kent part number 56391185) on top of the dust control housing. Reach in from the sides of the machine and push the bag
opening over each of the two tubes.
3
Put your foot on the support stand and gently lower the front of the machine to the floor.
The dust collection system will not operate properly if the collector bags are full, if just one bag is installed, or if one or both bags are torn.
PREPARING THE MACHINE FOR USE
