FORM NO. 56041422 - AquaSpot
™
- 8
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WARNING!
Use only nonflammable commercial chemicals intended for machine application.
1
Unsnap the Recovery Tank Latches (2) and remove the Recovery Tank (4) from the machine.
2
Pour up to 2 gallons (9 liters) of hot water into the Solution Tank (1).
NOTE: Liquid cleaning chemical can be added to water if desired. Follow instructions on the chemical bottle for proper dilution. Do not mix powdered
chemicals in the Solution Tank, mix them thoroughly in a bucket first. Undisolved powder can clog the solution pump.
3
Re-install the Recovery Tank (4) and secure with Latches (2).
4
Connect the Hose Assembly (6) to the machine, make sure the Solution Hose Coupler (14) is locked in place.
5
Plug the Power Cord (13) into a properly grounded outlet.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SPOTTING PROCEDURES PRIOR TO OPERATING MACHINE
1
Soak up excess liquids with a towel.
2
Test cleaner on a small inconspicuous area to make sure it will not damage the carpet fibers.
3
Apply appropriate spotter, follow directions on bottle.
4
Start at outside edges of stain and work toward the center. Use a dabbing, not a rubbing action.
5
Repeat steps 3-4 if needed.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
OPERATING THE MACHINE
1
Toggle the Power Switch (15) to the UP position to turn both the vacuum motor and the solution pump ON. With the Power Switch (15) in the
DOWN position, only the vacuum motor runs.
2
Place the Hand Tool (7) on the stain and squeeze the trigger while pulling back on the tool.
NOTE: Do not oversaturate the upholstery.
3
Check fluid level in the Recovery Tank (4) periodically. When the fluid reaches the Recovery Tank Full Indicator (10), shut the machine OFF
and empty the tank at a designated waste water “DISPOSAL SITE”.
CAUTION!
Do not continue to use the machine after the Recovery Tank is FULL. This will damage the vacuum motor and is NOT COVERED
UNDER WARRANTY.
PREPARING FOR USE AND OPERATING THE MACHINE
revised 2/01
