Nilfisk-Advance 56011781, Инструкция по эксплуатации

Страница: 18 / 53

Nilfisk-Advance Select Spray 1500E Operator's Manual 17
STORAGE & MAINTENANCE
WINTERIZING:
1. For storage and transportation purposes in subfreezing ambient temperatures,
it will be necessary to winterize this unit. This unit must be protected to the
lowest incurred temperature for the following reasons:
a. If any part of the pumping system becomes frozen: excessive
pressure may build up in the unit which could cause the unit to burst
resulting in possible serious injury to the operator or bystanders.
b. The pumping system in this unit may be permanently damaged if
frozen. FREEZE DAMAGE IS NOT COVERED BY WARRANTY.
If you must store your unit in an area where the temperature may fall below
32°F, you can protect your unit by following the procedure outlined below.
1. Gather the following items:
a. Two 5 gallon containers.
b. One gallon of antifreeze.(Nilfisk-Advance recommends and
environmentally safe antifreeze)
c. Water supply.
d. Three foot hose, 1/2-3/4 I.D. with a 3/4 inch male garden
hose fitting.
2. Procedure:
a. Shut off the unit and water supply.
b. Relieve system pressure by pointing the trigger gun in a safe
direction and squeezing the trigger until water flow ceases
to exit the nozzle.
c. Lock the trigger gun in an OFF position and remove the
nozzle.
d. In a 5 gallon container, mix the antifreeze and water according
to manufacturer's recommendations for the temperature
you are winterizing to.
NOTE: Proper winterizing is based on the recommended manufacture's instructions
listed on the "Protection Chart" shown on the back label of most antifreeze
containers.
e. Remove the water supply hose from the unit and attach the
3 foot hose securely to the inlet connection. Submerge the
opposite end into the antifreeze solution.
f. Point the wand into the empty container and start the unit.
g. Trigger the gun until the antifreeze begins to exit the wand.
Release the trigger for 3 seconds, then trigger the gun for 3
seconds. Continue cycling the gun several times until all the
antifreeze mixture is siphoned from the container.
h. Detach the 3 foot hose from the unit and drain any excess
antifreeze back into the 5 gallon container.
i. Disconnect the hose/gun/wand assembly from the unit and
drain any excess antifreeze back into the 5 gallon container.
j. Store the hose, gun and wand with the unit in a safe area.
k. Store antifreeze solution for next use or dispose of according
to state EPA laws.
3. Optional Procedure:
a. Shut the unit off.
b. Relieve system pressure by pointing the trigger gun in a safe
direction and squeezing the trigger until water flow ceases
to exit the nozzle.
c. Disconnect and drain the hose, gun and wand.
d. Start the unit and allow it to run until all the water exits the
unit. Once the water has stopped flowing from the unit, turn
the unit off.
NOTE: When using this procedure, caution should be used as ice
chips can form from drops of water which could cause the
unit to burst if starting before completely thawed.
STARTING UNIT AFTER EXTENDED STORAGE:
1. BE CERTAIN the unit is NOT plugged into the power source.
2. Prior to restarting the unit, thaw out any possible ice from the wand, gun, hose
and unit.
3. After following all "PREPARATION" instructions, start the unit momentarily
and immediately turn "OFF" to ensure all parts are lubricated before operation.
WARNING
RISK OF UNIT BURSTING!
DO NOT STORE OR OPERATE
UNIT IN A FREEZING ENVIRON-
MENT!