background image

Connections

If your amplifier or receiver
has "A" and "B" speaker pair
outputs, connect the SPS-6 to
the "A" points.  Do not con-
nect anything to "B".  This
will prevent the amplifier or
receiver from driving an
unusually low impedance
load.

Using the SPS-6 with Tube
Type Amplifiers

Virtually all tube amplifiers
must have a load connected
at all times. If the amplifier to
be connected to the SPS-6 is
a tube amplifier, be sure to
always have at least one pair
of speakers switched on at all
times. An alternative is to per-
manently connect a 150 ohm,
5 watt resistor across the tube
amplifier's output in parallel
with the SPS-6.

Impedance Matching

You will need to activate the
SPS-6's PROTECTION button
whenever the overall system
impedance might fall below

4 ohms.

TUNER    94.9

15

SPEAKER 2

SPEAKER 1

SPEAKER 4

SPEAKER 3

SPEAKER 5

SPEAKER 6

L

R

AMPLIFIER

L

R

L

R

+

+

+

+

--

--

+

+

+

+

--

--

L

R

L

R

+

+

+

+

--

--

L

R

L

R

+

+

+

+

--

--

Niles Audio

Corporation, Inc.
Miami, Florida  USA

NILES

150

150

SPEAKER 2

SPEAKER 1

SPEAKER 4

SPEAKER 3

SPEAKER 5

SPEAKER 6

L

R

AMPLIFIER

L

R

L

R

+

+

+

+

--

--

+

+

+

+

--

--

L

R

L

R

+

+

+

+

--

--

L

R

L

R

+

+

+

+

--

--

Niles Audio

Corporation, Inc.
Miami, Florida  USA

NILES

TOOLS REQUIRED

• 1/8" Standard Slotted

Screwdriver

• Wire Stripper

MODEL SPS-6 Speaker Selection System (continued)

NILES AUDIO CORPORATION

12331 S.W. 130 STREET   MIAMI, FLORIDA 33186   
TEL: (305) 238-4373   FAX: (305) 238-0185  INTERNET: www.nilesaudio.com

© 1999 Niles Audio Corporation. Niles, the Niles logo and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation. Printed in USA DS00098A

Connections

Receiver

Speaker Pairs

Protecting a Tube Amplifier

Tube Amplifier

150 ohm, 5 watt Resistors

APPLICATION NOTES

APPLICATION NOTES

When playing the following speakers:

1 or 2 pair of 8-ohm speakers

3 or more pairs of 8-ohm speakers

1 pair of 4-ohm speaker

2, or more pairs of 4-ohm speakers

Any combination of 4 and 8 ohm speakers

The Protection button should be:

OFF

ON

OFF

ON

ON

CEDIA

CUSTOM
ELECTRONIC
DESIGN &
INSTALLATION
ASSOCIATION

CHARTER MEMBER

Отзывы: