Niles RS5 Coral, Руководство по установке

Страница: 14 / 27

14
WWW.NILESAUDIO.COM
CONNECTING THE LOUDSPEAKER IN TWO-SPEAKER STEREO MODE
(ALL NON-SI MODELS AND SI MODELS THAT ARE WIRED IN TWO
SPEAKER STEREO MODE)
1. Strip two to three inches of the speaker cables’ outer jacket away from
the insulated conductors. Ensure that at least two inches of the separate
conductors are free. Do this on both loudspeaker connection cables.
2. Strip one half inch of insulation from the end of each conductor as show in
Figure 5 for both connection cables.
3. Connect one stripped end of the speaker cable coming from the amplifier to
the loudspeaker connection cable’s red wire of one cable and the connection
cable’s yellow wire. To connect the three wires, twist the stripped ends of the
wire together and screw down the wire nut on the twisted wires. The material
inside the wire nut will protect the stripped ends of the wire. However, if added
protection is desired, place a large amount of silicone sealant so the bottom
of the wire nut is encased and sealed. Pay attention to the markings on the
speaker cable. Each loudspeaker you connect must be connected to the
amplifier’s speaker wire in the same way.
4. Repeat step 3 with the connection cable’s black wires and the other stripped
amplifier speaker cable’s conductor.
5. Make sure your amplifier/receiver is turned OFF before making any
connections. Connect the opposite end of the speaker cable to the amplifier
or receiver. Start by performing step 1 and 2 on the speaker cable near the
amplifier. Paying attention to the markings on the speaker cable conductor,
attach the same conductor you attached to the red loudspeaker wire to the
positive (red) or (+) amplifier output terminal. Attach the other conductor to the
BNQMJàFSTOFHBUJWF CMBDLPS mBNQMJàFSPVUQVUUFSNJOBM
Figure 5.
Speaker wire preparation