TABLE OF CONTENTS
Introduction
2
Getting
Started
4
Installation
4
System
Operation
13
Optional
Accessories
14
Running Sensor
Cable in New
Construction 16
Concealing
Sensor Cable
in Existing
Walls
18
Specifications 22
R
E
M
O
T
E
C
O
N
T
R
O
L
A
N
Y
W
H
E
R
E
!
K
I
T
RCA2
Remote Control
Anywhere! Kit
WARNING – To prevent possible injury, the
following basic safety precautions should be
observed in the installation and use of your
Remote Control Anywhere Kit.
1.
Read through the entire manual
– Before attempting
any installation, read this manual thoroughly and keep it for
future reference.
2.
Avoid contact with all high voltage electrical wiring
and equipment!
3.
Keep away from water and moisture
– Never use or
install electronic products near water, ie., near a bathtub,
sink, washing machine, in a wet basement, near a swim-
ming pool, or anywhere else the product may be exposed
to water or moisture.
4.
Power supply cord protection
– Do not run the power
cord where it may be subject to wear or abuse. Do not
allow anything to rest on or roll over the power cord which
may damage it.
6.
Lightning
– It is suggested that you remove the power
supply from the wall if your system will not be used for long
periods of time. Power surges due to lightning strikes may
damage your equipment.
7.
Check your local building and electrical codes
–
There may be specific requirements regarding running low
voltage in your area.
DS00224CCN_RCA2 Kit.qxp 6/22/04 3:28 PM Page 1
