I
N T E L L I
P
A D
®
C
I
K
E Y P A D
M
O D U L E S
10
Installing the Master Key Labels
Included with each Master Keypad Module is a sheet of precut and preprinted labels for
your convenience. To install the labels follow these steps:
1.
Holding the Master Keypad Module as shown in
Figure 6
, remove the white Decora
style insert on the face of the keypad by pressing the top friction fit pegs from behind.
The insert pops free very easily with slight pressure. Pull the Decora-style insert away
from the keypad.
2.
Before installing labels, determine which color (white, bone or almond) Decora style
insert is appropriate for your installation and set the labels aside in a convenient place.
3.
Detach all the labels you will be using, and keep them on hand.
4.
Remove all plastic key caps from the elastomer as shown in
Figure 7
. Place them next
to the labels.
5.
If you are installing an Intellipad Ci Silencer along with a Master Keypad Module,
replace the original elastomer from the Master Keypad Module with the appropriate
elastomer for the Keypad Module you are installing as shown in
Figure 8
. Make sure
the elastomer is securely in place before proceeding. (Refer to the Intellipad Ci Silencer
Installation Guide for more information.)
6.
Pick up one plastic key cap at a time, and drop its corresponding label inside. See
Figure 9
.
7.
Hold the Master Keypad Module and firmly press each plastic key cap onto its corre-
sponding Master Key, as shown in
Figure 10
.
8.
Once all of the labeled caps are in place, take a look at your Master Keys. If they are in
the correct order, right side up and otherwise satisfactory, you may proceed. However,
if you need to correct one or more of the labels, remove the cap(s), adjust the label(s)
(as described in Step 4 and 6) and repeat step 7.
DS00266CCN-0 IntelliPad Ci.qxp 2/2/06 3:30 PM Page 12
