10
H
I G H
D
E F I N I T I O N
S
P E A K E R
S
E L E C T I O N
S
Y S T E M
3.
Make the connections to the HDL-6. The amplifier/speaker
connectors on the HDL-6 are removable. If you wish, you
may remove these connectors to facilitate installation.
(See
Figure 3)
. Strip 3/8" of insulation from the end of each wire.
Tightly twist the end of each wire until no frayed ends
remain. Insert each wire into the appropriate hole on the
spring-loaded connector terminals. Observe proper phasing
— connect the positive terminals on the HDL-6 to the
positive terminals on the amplifier and speakers, and the
negative terminals on the HDL-6 to the negative terminals on
the amplifier and speakers. If the connectors were removed,
reinstall them.
(See Figure 4)
.
4.
Locate the pre-printed room labels. Affix the appropriate
label to the recessed area over each ON/OFF selector button.
Figure 3
Removing the Connectors
Figure 4
Installing the Connectors
