TANK AND FILTER PREPARATION
1.
Take the clear 4-mil poly bags with breather holes and set it into the vacuum tank. There
are 1/2"
round holes (breather holes) located about 6" from the top of the bag. Take one of
these holes and stretch it open to approximately 3" in diameter. Using the 3" hole, pass the
tank down tube through the 3" hole and pull the entire bag up and over the rim, so the top
of the bag hangs over the outside of the tank. Make sure the bag is set-up so that the
vacuumed material coming into the intake and down tube will end up dropping into the
plastic bag.
IMPORTANT:
All the breather holes MUST be inside the tank.
2.
Place the paper collection bag into the bottom of the tank. Pull the cardboard/rubber collar
over the down tube, pulling it just above the rib on the down tube. Then gently pull apart
the accordion-like pleats so that the bag is expanded open.
3.
Place the cloth filter bag with ring in tank.
4.
Make sure the impaction pre-filter is in proper placement. (See instructions on changing
impaction pre-filter in the following section)
5.
Place the lid assembly onto the tank and snap the latches into place.
CAUTION:
Breather
holes on the poly bag MUST be inside the tank.
FILTER OPTIONS AND SUGGESTIONS
CHIMNEY CLEANING AND FINE DUST PICK-UP:
When using the vacuum for chimneys
it is recommended that all filters be in place to prevent premature loss of suction and to extend the
life of the HEPA filter. The poly bags can be eliminated when the paper collection bag is being
used. However, using the poly bag will make collection bag changes and disposal a cleaner, less
messy procedure.
DRYER VENT, LINT AND LARGE PARTICLE PICK-UP:
When using the vacuum
for
dryer vents, the paper collection bag may be eliminated, allowing materials to load directly into
the 4-mil poly bag. ALL OTHER FILTERS MUST BE IN PLACE. If you choose to eliminate
the paper collection bag, you can remove the lower section of the down tube (the rubber reducer
and metal tube). This will prevent any clogging that could be caused by lint and larger objects.
FILTER MAINTENANCE AND REPLACMENT INSTRUCTIONS
Warning: When a loss of vacuum power is detected, the vacuum should be turned off
immediately. Continued use of the machine could result in sever damage to the motor and/or
HEPA filter. This loss of vacuum power could be caused by one of the following:
A.
The paper collection bag may be full and needs to be replaced.
B.
The tank may be full and needs to be emptied.
C.
The wand, hose or down tube may be clogged and needs to be cleared.
D.
The black impaction pre-filter may be clogged and needs to be replaced. (Never try to clean
the impaction pre-filter, it should be discarded)
E.
The Cloth bag with ring may be clogged and needs to be cleaned or replaced.
F.
The HEPA filter may be clogged and needs to be replaced.
To prolong the life of the HEPA and motor, the paper collection bag should be changed when it is
1/2" full. The impaction pre-filter should be changed at least every other time that the collection
bag is changed.
