Nikon NPL-302 Series, Инструкция по эксплуатации

Страница: 80 / 234

3 Getting Started
60 Pulse Laser Station NPL-302 Series Instruction Manual
If the signal level is insufficient to take a measurement, the signal icon flashes on
and off. For more information, see Status bar, page 36.
Measurement settings
31.3
To view the measurement settings,hold down
[MSR1] or [MSR2] for one second.
Use [^] or [v] to move the cursor between the fields.
Use [<] or [>] to change the value in the selected
field.
To change the height of target (HT), temperature,
or pressure, press
[HOT] . For more information,
see [HOT] key, page 43.
Settings that relate to corrections
(T-P corr, Sea Level, C&R corr., and Map
projection) are included in the job settings. These
settings are job-specific. If you need to change
any of these settings, you must create a new job.
For more information, see Job settings, page 117,
and Settings, page 135.
Field Values
Target Prism
N-prism
Const (prism constant) –999 mm through 999 mm
Mode Precise
Normal
AVE (Average count) 0 (Continuous) through 99
Rec mode One of the following:
MSR only
Confirm
ALL