Nikon HQA46480, Инструкция по эксплуатации

Страница: 53 / 185

Total Station DTM-322 Instruction Manual 39
Getting Started 3
Entering a point from the point list
To display a list of existing points, press the
List
softkey when the cursor is in the PT field.
Use [^] or [v] to move the cursor to the point that you
want to use. Then press
[ENT]
.
When you return to the point input screen, the selected
point name is entered in the PT field. You can add
digits or alphabetic characters if required.
Entering a code
The CD (Code) field always defaults to the last code used. You can change the
selected code on the input point screen, or you can press
[COD]
in the BMS. For more
information, see [COD] key, page 30 .
You can use numeric or alphanumeric names up to 16 characters long to identify
codes.
Entering a code directly
To enter a code directly, press
[MODE]
to change the
input mode to alphanumeric or numeric mode. Then
use the keypad to enter the code.
Entering a code from the stack
The code stack is a list of recently used codes. The
stack may contain up to 20 codes.
To display the stack, press the
Stack
softkey when
the cursor is in the CD field.
Use
[^]
or
[v]
to move the cursor to the code that you
want to use. Then press
[ENT]
.
The selected code is copied to the CD field.
When the instrument is rebooted, the code stack is cleared.