9
2
Assembling
Before starting to assemble the DXM1200F system, read and observe the “Safety Precautions”
provided earlier in this manual.
[Installation locations]
•
Avoid bright room lighting and direct sunlight. Bright ambient light makes it difficult to
obtain clear images from the microscope.
•
Avoid dusty locations.
•
Avoid subjecting the product to vibration. The surface must be level. The DXM1200F is
extremely sensitive to vibration. Vibrations during image capture may result in images of
poor quality.
•
Avoid high temperatures and humidity. Mildew or condensation on the lens will result in
deteriorated performance or malfunction.
[Required tools]
Screwdriver, allen wrench (supplied with the microscope)
1
Mounting the interface board in the PC
Warning
Remove the power cable from the power connector on the
PC before mounting the interface board.
1. Read your PC instruction manual
Read your PC instruction manual
Read your PC instruction manual
Read your PC instruction manual before mounting the interface board.
2. Remove and save the screws from the PCI slot. You will be using these screws later
to secure the interface board.
3. Remove the cover from the PCI slot. Keep the cover for later use.
4. Carefully insert the interface board into the PCI slot. Avoid touching the
motherboard and other components. Make sure the board is fully inserted.
5. Use screws removed from the cover to secure the interface board. The board may
move when you tighten the screws, so hold the board level as you tighten them.
6. Fully insert the power cable into the power connector on the PC.
2
Attaching the C-mount adapter to the camera
1. Remove the rubber cushion cap from the camera.
2. Check that the C-mount adapter is clean and free of dust.
3. Screw the adapter fully into the camera. Ensure the adapter bottoms on the end.
