Niko 1-7805 Series, Руководство пользователя

Страница: 120 / 175

1XX-7805X
EN 119
• The Nikobus software is recommended for the programming
of automatic sensors (see section 4.5.2.).
• As soon as all the sensors are programmed, use the
potentiometers to set the desired light sensitivity and
switch-off delay.
4.5.1. Manual programming
A. In preparation for programming
1. Place the sensor to be programmed on the actuator.
2. Wait at least 30 seconds (initialisation time of the sensor) after
you have placed the sensor on the actuator.
3. Using a screwdriver, turn the potentiometer for light sensitivity
completely to the left ( ) and wait 5 seconds.
4. Switch the sensor to manual mode by briefly (< 5 s) pressing the
button on the top of the sensor.
Go back to the automatic mode to interrupt any possible previous
detection.