05-350 / 05-338
43
3.2. Programming, teach a transmitter
1. Apply 1 brief (<1.6s) press to the
prog.
button, a bleep signal sounds.
2. Use the
button to switch ON the desired channel on the receiver.
3. Select the function (see function table) using the
mode
01
23456789A
BCDE
F
rotary switch.
4. Select the relevant times (see time table) using the
time
01
23456789A
BCDE
F
rotary switch.
5. Press the push button to be programmed on the hand-held transmitter or wall-mounted
transmitter. This is acknowledged by a short bleep signal. Different transmitters can be
programmed. If the memory is full, you will hear a long 2s bleep tone.
6. If you select a function with 2-button or 4-button control via ‘mode’, you only need to press
one of the buttons. E.g. for mode 1 you only need to press the button at the top or bottom
to carry out the programming.
7. Apply a brief (<1.6s) press to
prog.
to end the programming.
noTe:
Additional transmitters (max. 32) can at any time be programmed on a receiver: repeat
‘PROGRAMMING’. If the memory is full, you will hear a long 2s bleep tone.
The programming is retained in case of prolonged power failures.
3.3. global reset
1. Apply 1 long (>1.6s) press to the
prog.
button until the special repetitive bleep signal
sounds.
2. Apply a second long (>1.6s) press to erase the complete memory.
EN
Содержание 05-338
Страница 1: ...05 350 05 338...
Страница 2: ......
Страница 75: ...05 350 05 338 75 2 1 N L N L 230V N L N N L L 1 10V 1 10V...