10
Troubleshooting
No heart rate displayed on watch:
The grooved sensors may not be wet enough.
Wet and try again. It is recommended that you wear
the Heart Rate Transmitter directly against your skin.
If you are wearing the HR Transmitter over clothing,
try getting the clothing wet also.
The HR Transmitter may not be positioned correctly.
Make sure the grooved sensors are flat against the skin.
Heart rate reading on watch is erratic or stops:
You may need to replace the battery in the HR Transmitter.
Sources of electromagnetic fields like appliances,
computers and power lines can cause interference.
Change your location.
This product complies with EN60601-1-2
Watch display is frozen:
The display of your watch may "freeze" due to static
electricity or recent battery replacement. If this occurs,
press and hold all four buttons at the same time.
This will erase the data in the memory and allow you
to reset the watch to the factory settings.
Watch beeps continuously:
If you have the zone alarm ON and your heart rate does not
fall within any of your zones, the watch will beep to indicate
you are out of your zones.
See page 7 for instructions on how
to turn OFF the zone alarm.
Specifications
IP code:
IPX8
Applied Part:
Type CF
Storage:
Standard Conditions (within operating temperature)
Watch
Water Resistant up to 50 Meters:
Designed for underwater performance
to a depth of 165 feet (50 m).
ATTENTION:
Water damage
will occur if watch buttons
are pressed while underwater!
Operating Temperature:
-5 to 50˚ Celsius
Material Specifications:
Crystal:
Mineral Glass
Case:
Polycarbonate
Buckle:
Stainless Steel
Bezel:
Stainless Steel
Caseback:
Stainless Steel
Strap:
Polyurethane
Mode Limits:
Chronograph:
23:59’59”
Heart Rate:
30 - 240 bpm
Heart Rate Transmitter
Water Resistant up to 30 Meters:
Wipe dry after use. Do not store among conductive material.
Operating Temperature:
-5 to 50˚ Celsius
Accuracy:
+
- 1% or +
- 1% bpm, whichever larger (steady state)
Material Specifications:
Case:
Polycarbonate
Strap:
Urethane
Band:
Elastic
Press and hold all four buttons
at the same time to reset
the watch to the factory settings.
