X K 3 1 9 0
–
A26
()
10
④
Indicator display
【
bAUd
】
（
chose communication baud rate chose
）
【
*
】
（
1200
、
2400
、
4800
、
9600
）
After input the baud rate required,press"clear"button confirm and finish the
communication parameter setting and back to weighing state.
In the parameter input process, press the "Accu"button, you can terminate the parameter
input, back to weighing mode.
1.
Communication format
.
Continuous communication format 0
：
There are 12 bytes in each frame data, and detailed format please check the diagram as
below.
The X byte
Content and Note
1
02(XON) Start
2
+or-
symbol position
3
Weighing data
（
display value
）
higher position
：
Weighing data
：
：
Weighing data
：
8
Weighing data low position
9
Decimal points digits from right to left
（
0
～
4
）
10
XOR checksum
high 4 digit
11
XOR checksum
low 4 digit
12
03(X0FF) end
The confirmation of higher 4 digits and lower 4 digits XOR checksum
XOR checksum operated in 16 hex byte way from byte 2 to byte 9. The high 4 and low 4
bits of checking result was conversion and transmit in ASCII code, conversion method are
as follows:
If less than, or equal to 9, then add 30h, will send a number of ASCII code, for example:
XOR checksum high 4 to 6, after adding 30h, 36h is ASCII code for the 6 to send;
If higher than 9, then add 37h, will send a letter ASCII code, for example:
XOR checksum high 4 bits of B, plus 37h, the ASCII code for the 42h that is sending B
Continuous communication format 1:
There are 9 bytes in each frame data, and detail format please check the diagram as
below.
The X byte
Content and Note
1
= start
2
Weighing data
（
display value including decimal point
）
lower position
：
Weighing data
：
