NightWatcher NW765, Инструкция по эксплуатации, Страница: 19 / 19

16
The NightWatcherHD camera real-time play has third modes: HD, SD and Automatic;
(1:) Real-time viewing while in HD mode, Asymmetric Digital Subscriber Loop
(2:) Real-time viewing while in SD mode.
(3:) Real-time viewing while in Automatic mode.
Power and physical issues
1. What if the camera stays off-line; Blue LED is not lit, camera does not move or transmit?
Check power to the device. Check circuit breakers, check fuse in fused spur. Remove NightWatcher from mount
and check power at device (Warning
– 240V mains power! Expertise and safe operating procedures apply.
2. The camera is hot; is it safe?
The device will operate normally with the range of -10°C to + 55°C. Extended use may cause the device to appear
hot but this is totally safe and will not affect operation.
If the camera remains off-line, please power the device off and on and reconfigure the WI-FI connection. If
necessary, delete the app and reinstall from start.
Operating systems supported
1. Which mobile phone operating system does NightWatcherHD currently support?
The NightWatcherHD App currently supports iOS 8.0 and higher and Android 4.4.0 and higher.
Specification questions
1. How does the night vision feature work?
The camera has High power lightning LED, it will be triggered when someone's moving and the light is less than 3
lux within 10 meters.
2. How many trigger events can be stored on the SD card?
3. What happens when the SD card is full?
When the memory card is full, it will over-write the earliest recordings. Video can also be backed up by removing
the SD card from the camera and saving to a PC or MAC
Camera LED code
Blue steady LED
– Light connected to WiFi in normal operation
Blue LED flashing 1/sec
– Connecting to WiFi
Blue LED flashing rapidly 2/sec
– WiFi resetting
Red LED
– The red LED may light very briefly in normal operation but if it comes on and stays on, or flashes fro
more than a few seconds this indicates a fault. May indicate the micro SD card has been removed or needs to be
re-formatted, See pages 3 and 4. Or it may indicate that the NightWatcher needs to be reset.
PIR window LED codes
Red
Orange
Green
See page 3
For further information and updated FAQs and downloads etc. visit
www.nightwatcher.co.uk/support