USER MANUAL
NIGHTSEARCHER LIMITED
Unit 4 Applied House, Fitzherbert Spur, Farlington
Portsmouth, Hampshire, PO6 1TT, UK
T: +44 (0)23 9238 9774 | F: +44 (0)23 92389788
Before using your NightSearcher product, please read this user manual, it contains
important safety information and operating instructions. Following this advice will help
ensure that your product operates to its maximum potential.
SPECIFICATION
Light Output
800 / 400 lumens
Light Source
1 Cree® XML LED
Running Time
8h / 14h
Charge Time
10-12h
Battery
4V 11Ah SLA Battery
Product Size (mm)
L260 x W150 x H180
Product Weight (kg)
1.6
NS Part No
NS750XML
Supplied with
Detachable shoulder strap and mains charger
LED ASSEMBLY REPLACEMENT
The Light Emitting Diodes (LED) can last 50, and seldom need to be replaced. If
there is any malfunction of LED, please contact Nightsearcher Limited or an authorised
distributor.
BATTERY INFORMATION
BATTERY CHARGING
Turn the flashlight to the OFF; connect the charger to the charging socket of the
Searchlight.
The LED indicator (located on the power pack) will turn RED.
When the battery is fully charged, the LED indicator will turn GREEN.
Disconnect the charger from the AC power supply and then disconnect the charger
from the Searchlight.
Recharge time is approximately 10h if completely discharged OR pro-rata if not.
Recharge for 12 hours before first use.
NOTE:
This Searchlight is powered by Sealed Lead Acid rechargeable battery. Sealed
Lead Acid batteries, require charging after every use and should not be left fully
discharged as this will damage the battery.
ON / OFF AND MODE OPERATION
NOTE:
The DC plug connection the light to the power pack should be removed before
packaging/in transit/storage to prevent the lamp from accidentally switching ON.
The functions are controlled by a rocker switch located on the rear of the head.
SEARCHLIGHT MAINTENANCE
Use a small brush or blow dry air to clean any dust inside the reflector.
Use lens cleaner and cotton swab, to remove any fingerprints on the lens.
Do not use the Searchlight for diving; it is not suitable for the high pressure
underwater environment.
If water gets inside the searchlight, remove the battery immediately and place in a
well-ventilated area.
CHANGING THE BATTERY
Unscrew two black screws located on the top of the power pack case
Remove the foam block holding the battery in place and lift the battery out of the
lamp
Pull off the crimp connectors careful not to touch them together and push onto the
new battery, ensuring a correct terminal connection (i.e. RED to positive, BLACK to
Negative)
Refit in reverse order of the above.
SAFETY PRECAUTIONS
Please read the instructions below before charging the flashlight:
BATTERY
Before using the lamp for the first time, or if you have not used it for a long time,
you need to fully charge the searchlight for 12hrs.
Do not expose the battery to excessive heat, to do so may cause an explosion.
Do not use metal objects to short circuit the positive and negative end of the
battery.
Do not dispose of the battery in the domestic waste, please use the correct
method of disposal.
Do not solder directly on to the battery.
Do not let the battery become wet or immerse the battery in water.