Contents:
- Lamp
- Pole fixings
- Wall fixings
- Remote controller
- User Manual
Installation:
- Install in a location where the solar panel will receive direct sunlight and not blocked or covered by
buildings, trees or other structures that would prevent the solar panel from charging sufficiently.
- Choose installation methods as desired (installing to a wall or pole as required).
- Recommendation Installation height: 3.5-4.5m. Pole diameter: 70-100mm
Distance between lamps: 10-15m.
- Activate the solar lamp to the light mode you require before continuing (see Operational
Instructions).
-
Please ensure installation kits are tightened firmly.
Install to a wall:
1. Mark out the required holes needed to mount the lamp.
2. Drill suitable holes and insert wall plugs either supplied of
suitable substitutes.
3. Position the lamp and secure into place with supplied or
other suitable fixing’s.
Charging time:
6 hours
Install to pole:
User can install to pole by provided
bracket and screws contained within
the kit provided.
Solar panel
12W 16V, Polycrystalline
Battery (in lamp)
4AH, 11.1V Rechargeable lithium battery
Lumen
1200lm
PIR distance / Detection range
6-12m/ 140°
Charging time
6 hours
Working temperature
-20°~+60°
IP Rating
IP65
Pole diameter
70-100mm
Dimensions
515x220x95mm
Weight
2.12kg
Stock code
NEXSUN-ST1200
Specification:
Operation:
Dusk to Dawn:
This solar light will automatically come on at dusk, and turn off during the daytime.
Movement activated (PIR):
The LED light will operate when motion is detected near the light.
Please note that the lamp needs to be turned on using the provided remote control.
PIR distance: 6-12m/140°
Brightness Adjustment: + / - LED
Press the + or - button to increase or decrease the brightness of the lamp.
Please note this button is effective only when lamp is under mode M1 or M2.
T1, T2, T3: Timer mode
T1=15s:
Set working time of high brightness under M1 or M2 to 15 seconds
T2=30s:
Set working time of high brightness under M1 or M2 to 30 seconds
T3=60s:
Set working time of high brightness under M1 or M2 to 60 seconds
Please note this button is effective only when lamp is under mode M1 or M2.
M1, M2, M3: working modes
M1:
If no motion is detected, the light will power at dimmed level for up to 8 hours in total. If motion
is detected, the light will switch to full power for you selected time (Exact timing length of high
brightness will depend on which time mode you have chosen: T1, T2, or T3).
M2:
If no motion is detected the light will remain off. Once motion is detected: light will illuminate to
full brightness for you selected time (Exact timing length of high brightness will depend on
which time mode you have chosen: T1, T2, or T3).
M3:
Light is powered in low mode from dusk, until battery is depleted of dawn.
How to use the remote control:
Press Red power button: To turn the lamp on/off the additional buttons control and change
the light level and timer modes.