Nietz NZE Series, Руководство пользователя

Страница: 140 / 144

· 134 ·
Operation Instruction of NZE Series Inverter
P027
Alarm code
BIT0 1: UC; 0: no alarm
BIT1 1: oc; 0: no alarm
BIT2 1: communication err.NF; 0: no alarm
BIT3 1: output loss phase LO; 0: no alarm
BIT4 1: OU; 0: o alarm
BIT5 reserved
BIT6 1: LU; 0: no alarm
BIT7 1: motor overload OL; 0: no alarm
BIT8 1: over torque OT; 0: no alarm
BIT9 1: overheat OH; 0: no alarm
BIT10 1: no 4mA signal; 0: no alarm
BIT11~BIT14 reserved
BIT15 1: alarm; 0: no alarm
read only 001BH
P028 BIT0: 0: FWD 1: REV
BIT1: 0: stop 1: un
read only 001CH
ASCII Mode:
Firstly setting: P101 = 5(freq. source);
P102 = 2(control mode);
P700 = 1(baud rate 9600);
P701 = 0(8N1 FOR ASCII)
P702 = 1 (Address)
1: set freq. ref:
write50.00HZ (1388H) to address 2001H
send char. HEX: 3A 30 31 30 36 32 30 30 31 31 33 38 38 33 44 0D
0A
receive char. HEX: 3A 30 31 30 36 32 30 30 31 31 33 38 38 33 44
0D 0A
2: set run command
write 02H to address 2000H
send char. ":010620000002 "CR LF
Send character HEX: 3A 30 31 30 36 32 30 30 30 30 30 30 32 44
37 0D 0A
Receive character HEX: 3A 30 31 30 36 32 30 30 30 30 30 30 32
44 37 0D 0A