MAINTENANCE
Oil Inlet Opening
Cleaning
* When total cleaning of the pug mill is desired clean the internal parts of the main body by
following the disassembly procedures.
1. Switch the power off.
2. Unplug the power cord from the outlet.
3. Remove the hopper cover and front outlet.
4. Remove two nuts that secure the nozzle to the screw case using the wrench supplied. Then
remove the nozzle from screw case.
5. Remove the four bolts that secure the clay hopper to the screw case using the wrench supplied.
6. Remove screw case by detaching four nuts that secure the screw case to the drive housing using
the wrench supplied.
1. Pull the lever down and install the hopper cover over the clay hopper.
2. Install the front cover over the end of the pug mill nozzle.
Precautions
*Rinse each of the disassembled parts with water and dry them well. Do not disassemble parts, which
are not described, since this may cause the pug mill to fail and will void the warranty.
Disassembly Procedures
Disassembly Diagram
In the event that it is
difficult to remove hard clay
remaining in screw case for
an extended period thread
the 1” bolt into the tapped
holes at the rear of the screw
case to gently pry the screw
case from the drive housing
Precautions
*Fuel oil or grease is not suitable for lubrication.
*Please do not inject unknown substances or water into the oil inlet opening.
