Nicotra RDP, Руководство пользователя

Страница: 6 / 21

6
Rev. 2 – 1
st
August 2017
5. Connection
There are two connection mode available: through a USB to RS485 o RS232 converter or through a Bluetooth.
5.1 USB to RS485
The steps for connecting the driver to the PC through the cable are:
- Select the driver slave address (default 1)
- Select the COM Port
- Select the Baud rate
- Select the Stop bits and Parity
- Press the connect Button
Fig. 9
5.2 Bluetooth
This chapter describes the connection between a HC-05 or HC-06 Bluetooth device (refer to the fan manual for the electrical
connections).
To use this connection the Bluetooth peripheral on the computer must be activated.
The HC module runs the SPP (Serial Protocol over Bluetooth) so any device supporting this protocol can be connected to it.
The operation to be ready with the connections are:
- Add a device from the computer Control Panel
The new device should be shown as in figure 10
Fig. 10