Nicols GLAM LASER, Руководство пользователя

Страница: 6 / 8

DMX ADDRESS CALCULATION
In DMX mode, the DIP switch from # 1 to # 9 should be set to record a DMX address. The address ranges from 1-511. Each dipswitch
represents a binary value. Please refer to table below.
Dipswitch VALUE Dipswitch VALUE
＃
1 1
＃
6 32
＃
2 2
＃
7 64
＃
3 4
＃
8 128
＃
4 8
＃
9 256
＃
5
16
＃
10
DMX, on "1"
Each unit has 12 channels. So each product may be receiving a 12-channel DMX address at least. If you assign an address on 16
channels, the DMX address is: 16
*N +1, N=0, 1, 2, 3….
One loop address=1, two loop address=17, three loop address=33, four loop address=49
Loop Address Binary Dipswitches
1 1 100000000
＃
1 (
＃
1 switch is ON, the others are OFF)
2 17 100010000
＃
1+#5 (
＃
1 and #5 switches are ON)
3 33 100001000
＃
1+#6 (
＃
1 and #6 switches are ON)
4 49 100011000
＃
1+#5+#6 (
＃
1,5,6 switches are ON)
The dipswitches setting for DMX address see the " DMX Address Quick Reference Chart ".
5. OPERATION
a. STAND ALONE OPERATION : Sound activation and AUTO
This mode allows a single device to react to the sound of music.
1. Place the device in a suitable and stable position.
2. Set the dipswitch to select AUTO or Sound active mode.
3. Turn on the unit. The unit resets then it begins to work.
4. The unit will react to low frequencies through the internal microphone. Adjust the sound sensitivity with the appropriate knob
located at the rear of the unit. The LED indicates whether the music mode is activated.
b. MASTER / SLAVE MODE
This mode allows you to connect up to many together without controller.
1. Install the unit in a suitable and stable position.
2. Choose a unit to function as master mode, set dipswitch to select AUTO or Sound active mode. The others must be set in slave
mode. Set the DIP switch to slave mode.
3. Use an XLR cable to connect devices together. Taken at the rear of the unit.
4. Turn on all units. The devices reset and then begin to work. The slave units will react the same as the master unit.
5. The units respond to low frequencies through the internal microphone. Adjust the sound sensitivity with the appropriate knob
located at the rear of the unit. The LED indicates whether the music mode is activated.