Nicols BLUE FIVE, Руководство пользователя

Страница: 21 / 22

UNIVERSAL DMX OPERATION
This mode allows you to use universal DMX-512 console to operate.
1. Install the units in a suitable position (laying of appending)
2. Use standard XLR microphone cable chain your units together via XLR connector on the rear of the
unit. For longer cable runs we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using dipswitches, see the “DMX Address Quick Reference
Chart”
4. Turn on the all units’ power, the units begins reset, then the unit begins working.
5. Use DMX console to control your units.
Notes:
DMX console can not be used in Master-Slave operation (Sound Active or AUTO mode)
There should be only one master unit in Master-Slave operation.
TROUBLESHOOTING
1. If the power supply indicator doesn’t light up and the laser doesn’t work, please check the
power supply and the input voltage
2. In Stand-Alone operation, if the power supply indicator is light up and Sound Active indicates
isn’t light up, but the laser is shut off doesn’t work

Because sound is too small make for laser shut off in Sound Active, please increase
the music volume or increase audio sensitivity with sensitivity knob, please check as
below

Please check if unit has been set up in Slave mode, then set up in Master mode.
3. In Master-Slave operation, slave unit doesn’t function, please check as below

Make sure to there’s only one Master in the chain, and the others are set in Slave
mode.

Make sure to control the unit without DMX console controlling
 Make sure to take a good quality power cable and connection
4. In DMX mode operation, the laser is OFF and the DMX signal indicator is unlighted, please
check as below:

Make sure to set up the DMX mode
 Make sure to have a good connection
5. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX signal
indicator is flashing, please make sure the DMX console and unit have the same channel.
6. If the output beam direction isn’t the right way, please restart the unit
7. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
If, after trying the above solutions, you still have problems, please contact your dealer or your
company for service.