1
3
2
3
1
2
4
4
5
ASSEMBLY
FINAL TRACK LAYOUT
This is a one-time snap.
Once these pieces are put together
they cannot be taken apart.
1. Attach the crank tower to the base until you hear it click
into place.
3. Load Blaze into the back of the launcher.
4. Pull the lever once until the LED lights start blinking
to rev up the launcher.*
*NOTE:
If you pull the lever more than once or do not
pull it down all the way the launcher may malfunction.
3. Attach the opposite tower into the base and launcher
until you hear it click into place.
5. Attach the track pieces together as shown
1. Peg the 2 obstacle towers into one of the 3 sets of holes on the track.
4. Slide the metal rod and the 2 screws into the launcher and
tighten with a Phillips screwdriver. Do not over-tighten.
2. Attach the launcher to the crank tower. Be sure it is facing
in the same direction as shown in the photo.
HOW TO PLAY
2. Slide the ramp into one of the 3 slots on the obstacle towers.
5
5. Release the launcher by pressing the lever
down on the side of the crank tower.
6
6. The Hyper Loop does a 360° fl ip and launches Blaze onto the track
and through the obstacle!
A
x2
x1
D
A
E
C
E
C
B
F
I
I
I
H
H
G
G
G
H
x
E
