Light Emitting Diode
This document contains tentative information, Nichia may change the contents without notice.
9/14
SP-QR-C2-220184-1
Jun. 8, 2022
Assembly Precautions for the Nichia 193F Series LEDs
Item
Recommended Conditions/Specifications
Cautions/Suggestions
Pick-and-place machine
Modular mounter
YS100 High-Speed General-Purpose Modular
(manufactured by Yamaha Motor Co., Ltd.)
Pick-and-place nozzle
Nozzle specifically designed for the LEDs (see Figure 3)
See “4.1 Pick
-and-
Place Nozzle” on Page 10 for details.
Tape-and-reel feeder
Electrical (motorized) feeder
Tape width: 24mm
Feeder pitch: 12mm
Top cover tape removal
position
Immediately before pick-up
See “4.2 Tape
-and-
Reel Feeder” on Page 11 for details.
Nozzle height for pick-up
operations
The contact surface of the nozzle head for pick
operations should be adjusted to 1.05mm below the
edge of the embossed carrier tape pocket.
See “4.3 Recommended Nozzle Height for Pick
-up
Operations” on Page 11 for details.
Nozzle height for placement
operations (i.e. placement
depth)
0.2mm for the placement depth
See “4.4 Recommended Nozzle Height for Placement
Operations (Placement Depth)” on Page 12 for details.
Imaging-based automatic
inspection
To locate the center of the LED, using the electrodes
and die heatsink as a reference is recommended.
See “4.5 Imaging
-based Automatic Inspection" on Page
12 for details.
4. Precautions for Setting up a Pick-and-Place Machine/Nozzle
Table 9. Cautions/Suggestions for Setting up the Equipment
