Nice HSDIM23, Инструкции и предупреждения по установке и использованию

Страница: 5 / 60

EN
3
03.
Check the coverage of the protected area: make short movements inside the area and
check the signals emitted by LED L1 ( fig. 2 ). Adjust the sensitivity value if necessary.
04. After adjusting the sensitivity, to reduce the risk of improper alarms, set dip-switch 3
to ON
(2 pulses per alarm).
05. After the operation check, it is advisable to set dip-switch 4 to ON to turn off the
signalling of LED L1 ( Fig. 2 ) and be compliant with standard 50131.
06. Turn dip-switch 5 ON to activate the anti-blinding function.
Caution! - The use of the Anti-blinding function excludes compliance with standard
EN50131.
07. If an extremely hot environment requires it, turn dip-switch 6 ON to activate the auto-
matic temperature compensation.
08. Close jumper JP1 ( fig. 2 ) to activate the double alarm function and acquire the sensor
in AND on itself.
Table 1 - Dip-switch programming
Switch Status Function
1-2 OFF OFF
Infrared sensor sensitive area up to 6 m (fig.
7
)
ON OFF Infrared sensor sensitive area up to 8 m (fig. 7 )
OFF ON Infrared sensor sensitive area up to 10 m (fig. 7 )
ON ON Infrared sensor sensitive area up to 12 m (fig. 7 )
3 OFF
No. of infrared pulses per alarm = 1 (fig.
10 A
)
ON No. of infrared pulses per alarm = 2 (fig. 10 B )
4 OFF Signalling LED active
ON Signalling LED off
5 OFF
Anti-blinding function disarmed
ON Anti-blinding function armed
6 OFF Temperature compensation off
ON Temperature compensation on