Nice E Star LT, Инструкция по установке и эксплуатации

Страница: 6 / 24

4 – English
EN
“ 1 ”
( )
S
5
position “ 0 ” position “ 1 ”
Force reduction on
closure (function
“RDC”)
position “ 2 ”
Fabric tensioning
(function “FRT”)
position “ S ”
Automatic hook-up
(function “FTC”)
Manual hook-up
(function “FTA”)
6
5.2 - Limit switch programming
Limit switches “ 0 ” and “ 1 ” ( fig. 5 ) correspond to the positions of the awning at the
end of the Up movements (“ 0 ”) and the end of the Down movements (“ 1 ”).
To select the procedure most suited to the system features, refer to fig. 7 .
• Note on “RDC” function
The RDC function prevents the canvas from remaining excessively tensioned at the
end of the closing ma noeuvre. The function automatically reduces the motor traction
torque during the final phase of the closing manoeuvre (to set the required torque
value, refer to paragraph 5.5).
This function is set at the factory, however it is not applicable if the limit switches are
programmed using the manual mode (paragraph 5.3). It can be disabled only dur-
ing the programming of the limit switches in semi-automatic mode (paragraph 5.4).
PROCEDURES
5.3 - Programming limit positions “0” and “1” MANUALLY
Caution! • This programming is recommended for awnings without casings. • The high limit switch (0) or the low limit switch (1) can be memorised at
the beginning according to your needs. • The RDC function cannot be enabled in these cases.
01. Use the Up or Down button to move the awning to the point of mid-travel. Note - during movement, 2 brief interruptions indicate that no limit position is memo-
rised.
02. Press and hold the Up pushbutton until the awning moves to the required limit position, then release the button.
03. Press and hold the two Up and Down pushbuttons simultaneously until the motor has completed a short down movement, then release.
04. Press and hold the Down pushbutton until the awning moves to the required limit position, then release the button. Note - during movement, 1 brief interruption
indicates that only one limit position is memorised.
05. Press and hold the two Up and Down pushbuttons simultaneously until the awning has completed one short up and down movement, then re lease.
“
0
”
5
sec.
02 01 03
05
5
sec.
1
“ 1 ”
04
THE
END
2
Manual procedure
paragraph 5.3
Semi-automatic procedure
paragraph 5.4
7
Manual procedure
paragraph 5.3
Semi-automatic procedure
paragraph 5.4
“ 1 ”
S
( )
“ 1 ”
S
( )
“ 1 ”
S
( )
“
1
”
S
( )
Semi-automatic procedure
paragraph 5.4
“FTC”
option
(paragraph 5.7)
“FTA” option (
paragraph 5.8
)
Manual procedure
paragraph 5.3
“FTA” option ( paragraph 5.8 )
4 – English