General
This service instruction describes how to upgrade NIBE
F1345 to make it compatible with NIBE Uplink™.
NOTE
This upgrade is only necessary if your heat pump
has a serial number lower than day number 150
(06511x
150
xxxxx).
In systems with several heat pumps only the
master needs to be upgraded.
NOTE
After electrical installation and upgrading the
software you should read the supplied user
manual for more information about NIBE Up-
link™.
Preparations
႑
Before upgrading we strongly recommend that you
register an account at http://www.nibeuplink.com/Re-
gister (if you do not already have an account) and
download the latest software for F1345 to a USB
memory stick.
႑
Save relevant menu settings on the USB memory stick
according to the guide on page 12. After upgrading
restore the menu settings via the same menu (7.3).
႑
Remove the panels from NIBE Uplink™ (front and
top).
Contents
Base card (AA2)
1 x
Input circuit board (AA3)
1 x
Display unit (AA4)
1 x
Service instruction, ESD protection
1 x
User manual, NIBE Uplink™
1 x
Remove the panels
Front cover
1
2
LEK
LEK
1.
Remove the screws from the lower edge of the front
cover.
2.
Lift the cover out at the bottom edge and up.
Top panel
LEK
1.
Remove the six screws on the sides of the top panel.
2.
Lift off the panel.
8
English, IHB - NIBE Uplink™ - Upgrade kit
GB
