Nibe F2030, Руководство по установке, Страница: 9 / 56

Transport and storage
F2030 must be transported and stored vertically.
NOTE
Ensure that the heat pump cannot fall over
during transport.
Assembly
■
Place F2030 outdoors on a solid level base that can
take the weight, preferably a concrete foundation.
If concrete slabs are used they must rest on asphalt
or shingle.
■
The concrete foundation or slabs must be positioned
so that the lower edge of the evaporator is at the
level of the average local snow depth, although a
minimum of 300 mm.
■
F2030 should not be positioned next to noise sensit-
ive walls, for example, next to a bedroom.
■
Also ensure that the placement does not inconveni-
ence the neighbours.
■
F2030 must not be placed so that recirculation of the
outdoor air can occur. This causes lower output and
impaired efficiency.
■
The evaporator should be sheltered from direct wind,
which negatively affects the defrosting function.
Place F2030 protected from wind against the evap-
orator.
■
Large amounts of condensation water as well as melt
water from defrosting can be produced. Condensa-
tion water must be led off to a drain or similar (see
page 8).
■
Care must be exercised so that the heat pump is not
scratched during installation.
LEK
LEK LEK
LEK
min 300 mm
Do not place F2030 directly on the lawn or other non
solid surface.
If there is a risk of snow slip from roof, a protective roof
or cover must be erected to protect the heat pump,
pipes and wiring.
7 Chapter 2 | Delivery and handling NIBE™ F2030
2 Delivery and handling