GETTING STARTED GUIDE
RTI-12308
Rear Transition Interface Generic DIO/AO/AI with MDR Headers
This document describes the features of the RTI-12308. You can use the RTI-12308 to connect
to any SLSC module supporting fully compatible rear I/O. The two 26-pin MDR connectors
provide access to up to 4 banks of signals for DIO, AI, or AO.
Note
Before you begin, read the
RTI-12308 Safety, Environmental, and Regulatory
Information
document on
and complete the software and hardware
installation procedures in your chassis documentation.
Installing the RTI-12308
Figure 1. Installing the RTI-12308 into the SLSC chassis
Caution
Do not touch the contacts or remove the I/O boards or cables while the
system is energized.
Complete the following steps to install the RTI-12308 in the chassis.
