NI Climbing Frames Karlas Kingdom, Инструкция по эксплуатации

Страница: 9 / 37

Tools needed:
•
Cordless drill
•
Handsaw
•
Spirit Level
•
Hammer
•
Shovel
•
Stepladder
•
Pencil
•
Measuring tape
•
10mm Hex bit
•
PZ 2 Drill Bit
Ground Preparation
1. Lay out the base and slide in the position that you intend the climbing frame to be placed.
Ensure the base is parallel of any buildings, fences etc. that you are wishing to match in with.
This will give you the size of the footprint the frame will take up in the garden. Allow for at
least 1.8m clearance beyond the end of the slide and 1.2m clearance for the steps, rock
module and swing module.
2. Once you are happy that the layout is correct, remove the slide.
3. Mark out clearly the centre of all 4 cut outs the platform base. Once these are marked you
can lift the bases out of your way and then dig your holes.
4. If the climbing frame is on a level surface, then dig the holes at a diameter of 12” and depth
12”. The tricky part is when the surface is uneven; in this case you would have to
compensate for the slope by making some holes deeper or shallower than others (minimum
depth of 10”). The bottoms of all h oles need to be level.