NHProEquip TC-1300, Руководство пользователя

Страница: 18 / 36

17
keep the tool arm at the work position.
Never place your hand on the wheel. The
column back to its work position will crash the
operator ( in between the rim and tool head.)
Move the tire making the bead pass under the tool head. The
buckling part of the bead will lean against the back of the
tool head. Use your hand to press the bead into the groove of
the rim. Step down the pedal
（
Fig5-1 K
）
making the turntable
rotate clockwise. Continue this operation until the tire is
completely into the rim.
To prevent the industrial accident, when the
turntable rotates, keep your hand and the other
part of your body far away from the tool arm.
Put in the tube, repeat the above operation
When demount and mount the tire, the turntable
will clockwise rotate. Counterclockwise rotate
on the condition that the machine turns off
causing the wrong operation and must make
correction.
6. Inflation
You should be very carefully when inflate the
tire. Seriously follow the following instruction
due to design of the tire changer does not
consider the prevention the persons around from
the accidental tire burst.
Tire burst will cause the serious injury or death
to the operator. Carefully check whether the
size of the rim and tire is the same. Before
inflation, you should check whether there is
any fault and abrasion on the tire. After each
inflation, you should check the pressure. All
of our tire changers is limited to the max.
inflation air pressure of 3.5
巴
equal to
51psi. No matter how, it will not exceed the
pressure value suggested by the manufacturer.
And keep your hand and body far from the
tire.
6.1Use the inflation gauge to inflate the tire. On
the condition of the standard mode, our tire
changers are equipped with the inflation gauge. The
process is as follows：
①Connect the inflation gauge with the core of the
tire
.
② Check whether the size of the tire is mating with
the size of the rim.
③ Check whether the bead has been fully lubricated.
If necessary, undertake the lubrication.
④Inflation，Check the air pressure of the pressure
gauge.
⑤ Continue inflation. Check air pressure while
inflation.