NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 134 / 330

4.8 Setting and Operation of Sweep
WF1967/WF1968 4-84
Select from continuous, single, or gated single.

P.4-75
• Sweep function [SwpFctn]
Select from one-way, shuttle.

P.4-75
It is possible to set with center phase [Center], and span phase [Span], instead of start phase, and
stop phase.

P.4-74
When sweep mode is single or gated single, it is necessary to set the trigger condition [Trig].

P.4-77
Set the following items as needed:
• Marker phase [Marker] (second page of the setting screen)

P.4-79
• Stop level [StpLvl] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Oscillation stop unit of the gated single sweep [OscStop] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Synchronization/sub output selection [SubOut] (third page of the setting screen)

P.4-79
4.8.6 Setting Amplitude Sweep
For the sweep setting screen and the common operation method, please refer to P.4-71, P.4-74
a) Amplitude sweep example
Examples of a continuous sweep and linear shuttle.
Shuttle sweep
b) To select amplitude sweep
c) Waveform or mode where amplitude sweep is unavailable
Amplitude sweep cannot be performed with DC.
AM and AM (DSB-SC) modulation are canceled (modulation function turned off) when amplitude
sweep is specified.
d) Items necessary for amplitude sweep
Set the following items on the second page of the setting screen. The amplitude setting on first page
of the setting screen becomes invalid, and the current amplitude is displayed.
• Starting amplitude [Start]
Select [Amptd] in the sweep type setting menu
When the oscillation mode [Mode] is set to
sweep oscillation mode [SWEEP], select the
sweep type [SwpType] on the second page of
the setting screen to display the selection list.
When amplitude [Amptd] is selected, amplitude
sweep is set.
Sweep value
Start value
Sweep time Sweep time
Stop value
Output signal