Part 4 - Operating Instructions - Removing
a)
Release the belt clip (when using the 3-point belt, release the
3-point belt from the shoulder belt).
b)
Remove the shoulder belt by releasing the mini buckle from the
tongue (depress the orange button on the mini buckle) and holding
the webbing let it retract back.
c)
Remove the lap belt by releasing the tongue from the stalk (depress
the orange button on top of the stalk) and holding the webbing let it
retract back.
d)
Open the over-centre buckles (depress the red release bars) and
feed a bit of webbing through.
e)
Detach the karabiners from the rings of the static straps and
remove the static straps from the wheelchair frame.
f)
Unclip the rear rail clips by lifting the red double plungers and
sliding slightly forward or backward.
g)
Release the wheelchair brakes and push the wheelchair forward
slightly.
h)
Detach the karabiners of the front straps from the wheelchair frame.
i)
Unclip the front strap rail clips by lifting the red plungers and sliding
slightly forward or backward.
11
b)
Position the wheelchair, facing forward, centrally between the rails
being used. Lock the brakes.
c)
Insert both front tie-down strap rail clips into corresponding holes of
adjacent rails, close enough to attach to the wheelchair, ensuring
the red plungers lock fully into rails (push down on the body of
the rail clip and slide forward / backward so they lock automatically).
d)
Attach the karabiners to the wheelchair frame, either at points
indicated on the frame, or, above the wheel axles on part of the
main frame. (Karabiners can face “in” or “out”, depending on
wheelchair design and which method fits best).
SIDE VIEW
FRONT VIEW
Front
Securement
Points
60°
40°
25°
25°
300
Wheelchair
Reference
Plane
All dimensions in mm
Diagram is for illustration only and shows
preferred positioning of front tie-down straps
4
