INPUT /OUPUT LINK CABLES
All the inputs are BALANCED for low noise and to give high quality from
professional equipment, but can be used for UNBALANCED sources by using the
XLR connectors as shown, although it is advised that the cable lengths be as
short as possible.
Each pair of sockets feature both MALE & FEMALE XLR type connectors and
can be used for BALANCED or UNBALANCED signals.
They are clearly marked Input & Output
A. = Unbalanced Input Male XLR B. = Balanced Input Male XLR
C. = Unbalanced Output Male XLR D. = Balanced Output Male XLR
Connecting the input signal: - The input signal can be connected to the XLR
input of either or both channels. The signal may come from any suitable line
level output, e.g., mixer or another amplifier (link output). All input
connections must use shielded/screened cables.
DO NOT CONNECT WITH SPEAKER CABLES.
The inputs are electronically balanced for those who require this facility,
XLR's configurations are pin 1 = ground , pin 2 = hot & pin 3 = balanced signal.
They can be used unbalanced, please make sure your XLR's are grounded on pins
1 & 3 with pin 2 as 'Hot' for this application.
Connecting a link signal: - Parallel Link s / ‘Daisy Chain’ hook ups should be
made using the appropriate Male XLR sockets.
OUTPUT CONNECTIONS
Connecting the output signal:-
A pair of SPEAKON™ connectors are
fitted and are wired +1 = S -
1 = Speaker - ; +2 & -2 are not
connected.
POWER CONNECTION
The wires in the mains lead are coloured:
Earth: Green/Yellow Neutral: Blue Live: Brown
As these colours may not correspond with the colour
markings identifying the terminal in your plug so
proceed as follows: Green/Yellow wire must be
connected to the terminal which is marked with the
letter E or coloured Green. - Brown wire must be
connected to the terminal which is marked with the
letter L or coloured red. - Blue wire must be connected
to the terminal that is marked with the letter N or
coloured black.
A.
B.
C.
D.
PLEASE NOTE
THIS AMPLIFIER AT FULL POWER
DRAWS A LEAST 13 AMPS
–
IT IS THRERFORE ADVISABLE
WHEN USING THIS ON A
DOMESTIC AC SUPPLY TO PLUG
DIRECTLY INTO THE POWER
SOURCE AND NOT INTO ANY
SHARED DISTRIBUTION UNIT.
