Nexus NX2 Compass, Инструкция по установке и эксплуатации

Страница: 29 / 40

English COMPASS
5-28
5.4 C70 Configure NX2
To return to normal mode, press SET when the text [rET] is
displayed.
In the configuration you will be able to tell the Nexus Network where
you
have installed the log and wind transducer.
This is important because you may optionally install those
transducers at the Server instead of the instrument.
5.4.1 C71 HDC-master
[On] = the Compass transducer is connected at the Compass Data
instrument.
[OFF] = the wind transducer is connected at the NX2 Server.
5.4.2 C72 Log-master
[On] = the log transducer is connected at the Compass Data
instrument.
[OFF] = the log transducer is connected at the NX2 Server.
5.4.3 C73 Function on terminal In3
Select function on the terminal pin 3. The following functions are
available:
If other function then water temperature is selected, you may still
use the water temperature function by connecting the NX2 log
transducer at the Server or at the Wind Data instrument.
[TMP] Standard temperature function for the log transducer.
[TRM] Use the external trim button for the SPEED Trim function.
[STR] Use the external trim button for the STEER Pilot function.
[MOB] Use the external trim button for the M.O.B. function.
[Roll] Use the roll sensor to compensate wind speed and angle.
(Not yet available, at the time for printing this manual).
When the selection roll is made, further settings in calibration can
be made to correct the offset angle. See C68 5.3.8.
When Speed TRriM [TRM] is selected, a press on the external trim
button will transmit the trim command on the Network. To be able to
set both steer
and trim reference, the optimum way is to connect
one trim button for speed to the Compass Data instrument and one
trim button for steer at the Server. Such an installation gives you
the opportunity to trim both speed and steer with separate buttons.