Nexus HPC Compass, Инструкция по установке и эксплуатации

Страница: 8 / 17

NMEA HPC COMPASS
English
13-7
3 Setup and deviation
The HPC Compass is adjusted and compensated from a PC with the use of the Hyper
terminal software which is a standard SW for Windows..
After installation:
1. Connect the power and NMEA data cable
2. Connect the PC cable to your computer
3. Start the hyper terminal SW
4. Set up the hyper terminal as follows:
Baud rate: 4800
Data bits 8
Parity: none
Stop bits: 1
Flow Control: None
5. Start to adjust the mounting angle of the HPC Compass. See below!
6. Auto deviate the HPC Compass See below!
7. Adjust the magnetic variation and misalignment See below!
3.1 Set-up from the Hyper terminal
3.1.1 Adjust the Heel and Trim
When the HPC is powered and connected to a PC you will get data out from it
(factory set is 4800 baud, 8bits, 1 stop bit, no parity)
Run the Hyper terminal and use the following command to adjust Heel and
trim
1. Make sure the boat is at 0° Roll and Trim
2. If you press ESC, the transmission stops
3. If you then press Z0 (Z and zero), the mounting plane
(vertical or horizontal) is set.
4. If you then press Z0 (Z and zero) again, the Heel and Trim
will be set to zero.
3.1.2 Automatic compass deviation compensation
Auto Deviation is performed by driving the boat in a circle up to
1¼ turn, so that the magnetic deviation can be measured, and by
that compensated.
1. Start a smooth turn of the boat
2. If you press ESC, the transmission stops
3. If you then press C1 to start the Autodeviation
4. When you have finished the turn press ESC and C2
to stop the Autodeviation